Bunny Balloon Modeling
Step 1: Take the balloon of the size 260 and inflate it, leaving about 2″/ 5 cm uninflated at the end. You will need them for the tail and to move the air inside the balloon as you twist. Look at the proportions of the model shown on the picture.
Step 2: Make one bubble for the bunny’s nose and two bubbles for the long ears. Make the bubbles, starting from the knotted end, and twist them in one direction by one hand. Hold the bubbles you’ve made in the other hand to prevent them from untwisting.
Step 3: Fold two top bubbles downward and twist the second and third bubbles together several times.
Step 4: Make one small round bubble for the neck and two bubbles of the same length as the nose for the forelegs.
Step 5: Fold the bottom bubble upward.
Step 6: Twist the second and third bubbles together several times.
Step 7: Make one bubble for the body, two long bubbles for the hind legs and one round bubble for the small tail.
Step 8: Fold two bottom bubbles over.
Step 9: Twist the second and third bubbles together several times.
Step 10: If you want to make the sitting bunny fold the hind legs upward and put the forelegs between them.
Step 11: Draw a face with a marker, and the bunny is complete.